HiiHoo! Talli/autokatos/"varasto" katsastettu!

 Tänään oli sitten se suuri päivä kun herra rakennustarkastaja kävi tontilla toteamassa rakennushässäkän olevan valmis.
Nyt on sitten "leima" papereissa ja voi alkaa sisustamaan "varastoa".

Ensimmäisenä nousi seinälle miljoonalaatikosto josta näyttää puuttuvan muutama laatikko. Missähän lienee?


Nyt on sitten vain mielikuvitus rajana eli voisi laittaa laminaatin lattiaan ja rakentaa baaritiskin grillikatoksesta ylijääneestä graniittitasosta.

Mistähän saisi mancaveen sopivan oluthanan?

Popular posts from this blog

Yeah!

Image
First real test run done. Yesterday evening before going to bed I set up the system with temp setting 85C and full magazine of smoke pucks. Oh, and one brisket. Unfortunately last night was a bit cold. System could not get temperature higher than 70C and due to a software bug (what was I thinking? Probaply nothing, as usual) feeder spent five hours worth of pucks in about two hours before getting jammed due to too low stepper motor current limiter setting. Anyhow... Brisket turned out tender, moist and delicious: This morning I changed the setting to cold smoking, put piece of salmon there, loaded magazine, set the temperature to 7C, started the system and slipped and slided to work. Soon (relatively soon, in a day or two) to be cold smoked salmon: After about 2hrs, I got message from home saying there is no more smoke! Went home during lunchbreak and checked the system. Again I built something with too tight tolerances. Apparently about 2% of smoke pucks are 3mm thicker than "nor
Read more

Smoke on the wat....

Image
Well. Technically yes because it was next to pool. First 2hrs test run went perfectly (after minor tweaking of limit switch). Oh, and the smoking evidence: Yes. It is not image manipulation. It really smokes.
Read more

Hiljaista tällä rintamalla...

Image
Lots have happened since last post. Just getting lazy to post new things here but perhaps this year brings a change. Status of ongoing projects: Flight Simulator Progressing slowly. Now when I have access to laser cutter/engraver, cnc mill and 3D printers I have started drawing plans for "general" gauge mechanics. "General" because it will be used as a basis for all gauges in future. Kitchen remodeling Almost done, two cabinet doors need some thinking because of hinge issues. Floor needs to be sanded and refinished. Replaced 30yrs old house fan with Vilpe 190p Eco . (It can be controlled with 0-10V DC signal so that will also be controlled by home automation system. Currently there is just a pontetiometer in kitchen for speed control.) Also replaced 30+yrs old Valmet range hood with Savo PK26 . Installation was quite difficult because I had to remove some unneeded parts first. I wonder if this voids the warranty... Now pulling the hood open contro
Read more