New project emerging...

No details revealed yet, just this concept picture:

Popular posts from this blog

Yeah!

Image
First real test run done. Yesterday evening before going to bed I set up the system with temp setting 85C and full magazine of smoke pucks. Oh, and one brisket. Unfortunately last night was a bit cold. System could not get temperature higher than 70C and due to a software bug (what was I thinking? Probaply nothing, as usual) feeder spent five hours worth of pucks in about two hours before getting jammed due to too low stepper motor current limiter setting. Anyhow... Brisket turned out tender, moist and delicious: This morning I changed the setting to cold smoking, put piece of salmon there, loaded magazine, set the temperature to 7C, started the system and slipped and slided to work. Soon (relatively soon, in a day or two) to be cold smoked salmon: After about 2hrs, I got message from home saying there is no more smoke! Went home during lunchbreak and checked the system. Again I built something with too tight tolerances. Apparently about 2% of smoke pucks are 3mm thicker than "nor...
Read more

HiiHoo! Talli/autokatos/"varasto" katsastettu!

Image
 Tänään oli sitten se suuri päivä kun herra rakennustarkastaja kävi tontilla toteamassa rakennushässäkän olevan valmis. Nyt on sitten "leima" papereissa ja voi alkaa sisustamaan "varastoa". Ensimmäisenä nousi seinälle miljoonalaatikosto josta näyttää puuttuvan muutama laatikko. Missähän lienee? Nyt on sitten vain mielikuvitus rajana eli voisi laittaa laminaatin lattiaan ja rakentaa baaritiskin grillikatoksesta ylijääneestä graniittitasosta. Mistähän saisi mancaveen sopivan oluthanan?
Read more

Home automation. How hard can it be?

Now when I have acquired some very nice hw from LowPowerLabs, how hard can it be to write a piece of code for it to control Nexa home automation modules? The recent kitchen renovating project in our house made me think if I could control house fans, lights, car block heater etc. remotely without paying arm and leg for the system. Long and exhaustive search in vast deeps of internet brought me to Lowpowerlabs website. They have a very nice system there: http://lowpowerlab.com/shop/moteino-r4 Arduino-compatible Moteino-board with builtin RF transceiver for a very reasonable price! And wait! That's not all! Those boards can even be programmed remotely over RF! what a piece of hardware. Could be useful in lots of projects. Now if I just could figure out a way how to control Nexa-modules (http://www.nexa.se/) with Moteino. Nexa controls remote devices through 433.92MHz frequency with a quite simple protocol.  People in internet have already managed to cont...
Read more